Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Exhaust- Monster Exhaust, Single Passenger side exit '07-10 User Manual
Page 5
96566 v.3.0
5
8.
Route the Front Tailpipe over the
rear axle housing and install onto the
flanged intermediate pipe outlet. Be
sure that the two pipes are completely
engaged. Loosely snug the 4” hanger
clamp.
9.
Install a 4” exhaust clamp onto the
inlet of the Rear Tailpipe. Install the
Rear Tailpipe onto the outlet of the
Front Tailpipe. Insert the Rear Tailpipe
hanger pin into the factory rubber
hanger. Rotate the tailpipe until the
hanger pins are parallel with the frame
mounted pin. Slide the 4” clamp and
position as shown in Figure 3. Loosely
snug the 4” clamp.
NotE: Maintain an adequate air gap
clearance of one (1) inch between the
exhaust and the shock absorber and
between the exhaust and the spare tire.
NotE: Minimum distance between
exhaust tip and body is one (1) inch.
10.
Adjust each of the pipes to ensure
that all of the hanger pins are parallel
with the frame mounted pins and that
the rubber hangers are all positioned
slightly forward (See Figure 2). The
amount of forward angle on the rubber
hangers should increase the farther
downstream the hanger is positioned.
This allows the hangers to be properly
positioned once the exhaust system
reaches operating temperature.
11.
Figure 3 illustrates the proper
location of an exhaust clamp on a
tubing joint. Torque the nuts on each
of the exhaust clamps to 35 ft-lb.
NotE: the clamps only need to be tight
enough to form a seal and hold the pipes
together. over tightening the clamps
may cause the system to leak due to the
pipe being crimped.
Figure 3