Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Exhaust- Monster Exhaust, Split-Dual, out the sides '04-07 5.9L HO 325hp Trucks, Including Mega Cab - Manual (Page 9)

96442 v.6.0
9
the fuel tank and attach to the bed. Zip
tie the vent hose and brake line to the
emergency brake cable, away from the
tailpipe.
16.
Adjust each of the pipes to
ensure that all of the hanger pins
are parallel with the frame-mounted
pins and fully inserted in the vehicle’s
rubber grommets.
17.
Be sure that the two (2) tailpipes
are completely engaged into the
Y-pipe. Rotate the tailpipe until the
hanger pins are parallel with the
frame-mounted pin.
Note: Recommended distance
between exhaust tip and body is a half
( 1 ⁄
2
”) inch.
18.
Beginning with clamps closest to
the catalytic converter, and working
your way back, align the saddle clamps
on the radius of the corresponding
pipe slots. Figure 2 illustrates the
proper location of an exhaust clamp
on a tubing joint. Torque the nuts on
each of the exhaust clamps to 35 ft-lb.
19.
Remove the protective covering
from the tailpipe tip. CAUTION: The
protective covering may ignite
and burn if not removed prior to
running the engine.
20.
Your system includes two (2)
Banks power logos. The logos can
be mounted 1 ⁄
2
” to 1” above the
“Cummins Turbo Diesel” emblem on
the driver-side and passenger-side
front fenders.
21.
Re-connect battery terminals if
previously removed. Start the engine
and listen for exhaust leaks. Tighten
the exhaust clamps as necessary.
Whenever possible, tack weld slip
connections to prevent disengagement
is recommended. The Banks Monster
Exhaust installation is now complete.
DRIVER SIDE
TAILPIPE
DRIVER SIDE
FRAME
HANGER
BRACKET
7/16” BOLT
& WASHER
SPARE
TIRE
7/16”
NUT &
WASHER
2“ X 2”
PLATE
Figure 3