Banks Power Ford Trucks: (Gas ’04 - 08 F-150 V6 & V8) Intake- Banks Ram-Air Intake system '04-08 F150 5.4L User Manual
Page 12
12
96881 v.5.0
20.
Locate the Banks filter cover.
Install the Banks filter onto the Banks
filter cover. Tighten Banks filter hose
clamp. See Figure 12.
21.
Insert Banks filter cover onto the
Banks air housing. Locate supplied
5
⁄
16
-18 screws and fasten the cover
to the housing. Note: make sure the
Banks cover is lined up correctly. See
Figure 13.
22.
Locate the previously removed
stock intake snorkel gasket and install
it onto the Banks housing as shown.
See Figure 14.
23.
Locate the grommets supplied in
your kit and install as shown in Figure
15. Install the grommet end into the
larger hole then slide into smaller hole.
Do both grommets.
24.
Locate the supplied bellows and
bellows hose clamps. Fit both hose
clamps onto each end of the bellows.
Install one end of the bellows onto the
Banks housing then tighten the hose
clamp.
25.
Install Banks housing into vehicle
compartment. Insert snorkel into stock
air intake opening then slide Banks
housing feet into previously installed
rubber grommets. See Figure 16.
26.
Fit the Banks bellows into the
Banks High Ram Intake. Tighten the
hose clamp.
27.
Re-connect battery grounds.
28.
You have successfully completed
the installation of the Banks Ram-Air
Intake system. See Figure 17. Make
sure to go over all hose clamps for
tightness and connectors for a sure fit.
Make sure that the intake tube is not
touching any engine components.
-END, SECTION 2-
Figure 12