Banks Power Ford Trucks: (Gas ’04 - 08 F-150 V6 & V8) Intake- Banks Ram-Air Intake system '04-08 F150 5.4L User Manual
Page 9
96881 v.5.0
9
9.
Using the supplied screws, lightly
tighten the MAF sensor to the Banks
High-Ram intake tube.
10.
Remove the stock throttle body
gasket from stock air filter housing.
See Figure 8.
11.
Insert throttle body gasket onto
the Banks High Ram. Make sure the
throttle body gasket is installed flush
past the beaded lip.
12.
Install the supplied brackets using
the supplied phillips head screws
(
1
⁄
4
-20) screws to the Banks High Ram.
Install the ‘wide’ bracket on the side
with the aluminum hose connection as
shown. See Figure 9.
13.
Install the Banks High Ram onto
throttle body. Make sure to fit all the
way flush to bottom of the throttle
body lip.
14.
With the two supplied brackets
fastened to the Banks Ram Air Intake,
align the brackets to the intake
manifold. Fasten the brackets to
the engine manifold using the four
supplied M6 flange head bolts. Note:
These are the only metric bolts in the
kit. See Figure 10.
15.
Remove the stock air intake hose
‘L’ bracket attached to the power
steering reservoir bracket. See Figure
11.
16.
Reinstall the stock nut to refasten
the stock power steering reservoir
bracket. Note: Only one nut will be
used to refasten the stock power
steering bracket.
17.
connect the MAF connector to
MAF sensor.
18.
connect the factory PcV vent
hose to the PcV connection on the
Banks Ram Air Intake.
19.
Locate the supplied filter hose
clamp and install on filter.
Figure 7