Cleaning and oiling the banks ram-air filter – Banks Power Ford Motorhomes: (Gas ’93 - 97 7.5L Class-C) PowerPack system (Class-C) For Use w_ 460 EFI Engine User Manual

Page 12

Advertising
background image

12

notification

The Banks Ram-Air Filter comes pre-oiled and

no oiling is necessary for initial installation.

Service the Filter as specified in this Section.
Use Banks ram Air filter cleaning system (part

#90094) availalbe from gale banks engineering

to service the air filter. Follow the instructions

included withthe cleaning system to clean and

re-oil your Banks Ram-Air Filter.

1. Pre-cleaninG

tap the element to dislodge any

large embedded dirt, then gently

brush with a soft bristle brush.

NOTE: If complete cleaning is

not practical at this time, re-oil

the element and reinstall in your

vehicle.

2. sPray-on cleaninG

spray banks air-filter

cleaner liberally onto

the entire element and

let soak for 10 minutes.

Pan cleaninG

large air-filter elements

can be rolled or soaked

in a shallow pan of banks

air-filter cleaner. remove

immediately and let soak for

approximately 10 minutes.

3. cleaninG hints

use only banks air-filter cleaner. no gasoline

cleaning, no steam cleaning, no caustic cleaning

solutions, no strong detergents, no high-pressure

car wash, no parts cleaning solvents. any of these

nos can cause harm to the cotton filter media plus

shrink and harden the rubber end caps.

4. rinse off

rinse off the element with

low-pressure water. tap water

is okay. always flush from the

clean side to dirty side. this

removes the dirt and does not

drive it into the filter.

5. dryinG hints

always dry naturally. after rinsing, shake off all

excess water and let the element dry naturally. do

not use compressed air – do not use open

flame – do not use heat dryers!

excess HeaT Will sHrink THe cOTTOn filTer

media. compressed air will blow holes in the

element.

6. aerosol oilinG

after cleaning air filter always re-oil

before using. spray banks ram-

air filter oil down into each

pleat with one pass per

pleat. wait 10 minutes and

re-oil any white spots still

showing.

7. oilinG hints

never use a banks ram-air filter without oil (the

filter will not stop the dirt without the oil). use

only banks ram-air filter oil. banks air-filter oil is

a compound of mineral and animal oil blended

with special polymers to form a very efficient

tack barrier. red dye is added to show just where

you have applied the oil. eventually the red color

will fade but the oil will remain and filter the air.

neVer use automatic transmission fluid. neVer

use motor oil. neVer use diesel fuel. neVer use

wd-40, lps, or other light-weight oils.

8. re-install

reinstall your banks ram-air filter element with

proper care. make sure the element seats properly

in the filter case. install the cover making sure it’s

in the right position. tighten all the nuts, bolts,

screws or clips to factory specifications.

9. do not discard

affix the “do not discard” sticker to the filter case

(included with every banks replacement element).

make sure you put the sticker in a highly visible

place to alert your mechanic not to discard.

10. Performance hints

service every 50-100,000 miles on street-driven

applications. service more often in offroad or

heavy-dust conditions. if an air-filter restriction

gauge is installed, then change the element when

the air-filter restriction reaches 18”/h

2

o.

caution!

extremely fine dust from agriculture

or offroad use will pull the oil from the element.

frequent re-oiling of the element’s clean side might

be required. completely service when practicable.

for extra protection use an air-filter sealing grease on

rubber ends of the element. service only with banks

air-filter cleaner and banks air-filter oil.

Cleaning and Oiling the banks ram-air Filter

12

96360 v.4.0

Advertising