Baron Grips & Risers_BLACK LINER PULLBACK RISERS Yamaha Roadliner_Stratoliner - Manual (Page 2)

Page: 2 BA-7422-00
LINER PULLBACK RISERS - Yamaha Roadliner & Stratoliner
1. Loosen the two 12mm bolts at the front of the tank (do not remove, just loosen them slightly).
2. Loosen the two 10mm bolts at rear of the tank (do not remove, just loosen them slightly).
3. Insert flat-tip screwdriver into adjusting slot between the front two 12mm bolts and rotate the screwdriver
towards the rear of the bike - this pushes the tank towards the rear.
4. With pressure still on the screwdriver, tighten the front 12mm bolts firmly, and then remove the screwdriver.
Be sure the bolt heads are parallel to one another once tight. The mount bracket and fuel tank must be square
to the frame.
5. Place a hand on each side of the tank just above where it is recessed for the speedometer and push
downward, being sure the tank is seated properly.
6. Tighten the two 10mm rear bolts firmly. 7. Replace the chrome dash and be sure it seats properly as you bolt
it into place.
LINER PULLBACK RISERS INSTALLATION:
1. Place a towel over the tank and headlight assembly so as not to scratch anything.
2. Using your fingernail, pry off the caps to the stock risers.
3. While your helper steadies the handlebars, use a 6mm allen wrench to remove the allen bolts holding the
riser caps on.
4. With a 17mm wrench or socket, remove the acorn nut on the bottom of the risers that holds them into the
triple tree. Slide the stock risers out of the stock triple tree.
5. You will note a chrome hydraulic line guide which routes the brake and clutch lines on each side of the
headlight. The brake line needs to be removed from the guide in order to provide additional length in the line
and prevent cable binding. Simply roll the line out of the guide. We suggest removing the line guide altogether.
6. Liner's have a greenish electrical line guide located at the bottom right (brake side) of the headlight. Grip the
hoop the wiring runs through and pull/bend it upward, or unbolt and remove it from the bike. This provides
added length to the electrical lines.
7. Assemble the new riser hardware by removing the riser caps off the unit with a 6mm allen wrench.
8. Insert one supplied 3/8-16 socket head cap screw into each riser.
9. Place one spacer on the underside of each riser bolt and slide into stock triple tree.
10. Secure risers to triple tree with supplied 3/8" washers & locknuts, using a 5/16" allen wrench and 9/16"
open ended wrench or socket.
11. Center handlebars on the new risers and secure one cap at a time to the new risers with the supplied
hardware and the 6mm allen wrench. This is easiest to do when the bars are turned to the opposite side of your
working area. Do not tighten completely at this time.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]