Baron Grips & Risers_BLACK LINER PULLBACK RISERS Yamaha Roadliner_Stratoliner - Manual (Page 3)

Page: 3 BA-7422-00
LINER PULLBACK RISERS - Yamaha Roadliner & Stratoliner
12. Adjust the bars to the desired height. Tighten the left or right riser cap with 6mm allen wrench, making
sure to tighten the bolt closest to the rider completely first, and then tighten the one furthest away. Repeat for
the other side.
13. To relieve pressure on the front brake hose and the throttle cables, be sure the throttle cables route above
the brake hose as they pass over and around the fork cover.
14. Generally the front brake banjo at the master-cylinder is rotated to a position that puts pressure on the
junction where the hose passes into the fitting. Being careful not to activate the brake lever, loosen the allen
banjo bolt at the master-cylinder only enough so you can rotate the fitting to take pressure off the hose by
aligning the hose with the compression fitting.
IMPORTANT HANDLEBAR ADJUSTMENT:
Take the handlebar and turn it to full lock to the LEFT. Hold the bar up and loosen the RIGHT rear riser
bolt. Turn the bars to full lock to the RIGHT. Hold the bar and loosen the LEFT rear riser bolt.
Rotate the bar downward towards the tank, and place three fingers in the Boy Scout Salute" under the
bottom of the electrical control housing. When the housing contacts your fingers you can stop and tighten
the bars.
You will likely need to adjust the brake and clutch levers to new rotations that align with your fingers as
preferred.
Test ride the bike for at least one hour to determine if the new position is correct for you. You can try
different positions to find the one you prefer. We suggest you think about the way your neck and shoulders
feel during and after riding in order to find the best position for you.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]