Wilwood MasterCylinder No: 260-3501 - Manual

DYNAMIC BLEED SYSTEM
INSTALLATION DIAGRAM • INSTRUCTIONS
4700 Calle Bolero • Camarillo, CA 93012 Phone 805 / 388-1188 • Fax 805 / 388-4938
www.wilwood.com • E-mail Technical Assistance: [email protected]
The Wilwood Dynamic Bleed System (WDBS) has been designed for maximum use brake applications where severe
rotor, pad and caliper temperatures are maintained for extended periods of time. The WDBS allows small amounts of
brake fluid to be circulated within a closed loop system each time the brake pedal is depressed. This helps to eliminate
localized fluid boiling and build-up of gases within the brake fluid, resulting in a firmer, more consistent pedal. The
WDBS consists of two (2) one-way flow valves and a special crossover return tube to replace the bleed screws (refer
to the diagrams below). Systems for the Prolites, Integras GT III, GT 6000, GT, GN III, and most Superlite calipers
are “in-stock” items and readily available. Applications include both single and dual master cylinder systems.
FLOW
260-3501
FLOW
260-3501
FRONT MASTER
CYLINDER
FLOW VALVE
FLOW VALVE
TEE FITTING MUST BE LOCATED DIRECTLY ON
THE MASTER CYLINDER, OR STACK TWO (2)
BANJO FITTINGS
FLOW VALVES SHOULD BE LOCATED AS CLOSE
AS POSSIBLE TO THE MASTER CYLINDER AND
BEFORE THE LINES TEE OFF TO CALIPERS
FRONT CALIPERS
BLEED LINE
FLOW
260-3501
FLOW
260-3501
MASTER
CYLINDER
FLOW V ALVE
FLOW V ALVE
FLOW V ALVES SHOULD BE LOCATED AS CLOSE
AS POSSIBLE TO THE MASTER CYLINDER AND
B
EFORE THE LINES TEE OFF TO CALIPERS
TO REAR BRAKES
F RONT CALIPERS
BL EED LINE
Balance Bar Dual Master Cylinder Set-up, Flow Valve Installation Diagram
“Fruit Jar” Set-up, Flow Valve Installation Diagram
WARNING
IT IS THE RESPONSIBILITY OF THE PERSON INSTALLING ANY BRAKE COMPONENT OR KIT TO DETERMINE THE SUITABILITY OF THE
COMPONENT OR KIT FOR THAT PARTICULAR APPLICATION. IF YOU ARE NOT SURE HOW TO SAFELY USE THIS BRAKE COMPONENT OR
KIT, YOU SHOULD NOT INSTALL OR USE IT. DO NOT ASSUME ANYTHING. IMPROPERLY INSTALLED OR MAINTAINED BRAKES ARE
DANGEROUS. IF YOU ARE NOT SURE, GET HELP OR RETURN THE PRODUCT. YOU MAY OBTAIN ADDITIONAL INFORMATION AND
TECHNICAL SUPPORT BY CALLING WILWOOD AT (805) 388-1188, OR VISIT OUR WEB SITE AT WWW.WILWOOD.COM. USE OF WILWOOD
TECHNICAL SUPPORT DOES NOT GUARANTEE PROPER INSTALLATION. YOU, OR THE PERSON WHO DOES THE INSTALLATION MUST
KNOW HOW TO PROPERLY USE THIS PRODUCT. IT IS NOT POSSIBLE OVER THE PHONE TO UNDERSTAND OR FORESEE ALL THE ISSUES
THAT MIGHT ARISE IN YOUR INSTALLATION.
RACING EQUIPMENT AND BRAKES MUST BE MAINTAINED AND SHOULD BE CHECKED REGULARLY FOR FATIGUE, DAMAGE, AND WEAR.