Nemco Food Equipment Hot Dog Roller Grills - Operations Manual - Manual (Page 2)

2
Model Series: 8010(V), 8018, 8027, 8036, 8045W, 8045N, & 8075
Includes Chrome, or GripsIt, Flat or Slant, and 120 Volt or 220 Volt Units
OPERATING AND MAINTENANCE INSTRUCTIONS
AND SERVICE PARTS LIST
INTRODUCTION
1.
Please read instructions before using
2.
Clean machine thoroughly before and after all uses using cleaning instructions below
3. This machine will be HOT during use and for a short time after it is turned off – BE CAREFUL
SAFETY INSTRUCTIONS
1.
Plug electrical cord into a certified electrical outlet with a corresponding voltage rating as listed on the
machine model labels. Units with two cords must be plugged into outlets on individual branch circuits.
2. There is one motor in the units that have one on/off switch.
3. There are two motors in units that have two on/off switches. The left switch controls the rotation of the
front set of rollers and the right switch controls the rotation of the rear set of rollers.
4. On units with two temperature controls, the left dial controls the front half of the rollers which are
denoted by black bearings. The right dial controls the rear rollers which have white bearings.
5.
Units with four temperature controls operate from left to right across front panel.
♦ Switch #1 controls the heat in the front four rollers 1-4 which are designated by black bearings.
♦ Switch #2 controls the heat in the next four rollers 5-8 which are designated by white bearings.
♦ Switch #3 controls the heat in the next four rollers 9-12 which are designated by white bearings.
♦ Switch #4 controls the heat in the next four rollers 13-16 which are designated by black bearings.
PREPARATION
1.
Set unit on a flat surface
2. Position unit near the power outlet. Avoid the use of extension cords.
3. Clean unit thoroughly before use.
4.
If unit fails to operate properly when first installed call NEMCO customer service at 1-800-782-6761.
STARTUP
1.
Turn on/off switches to the on position and make sure rollers are turning.
2. Turn temperature controls to desired temperature
♦ Knob setting #2: temperature is at 150º ; HOLD
♦ Knob setting #4: temperature is at 180º ; HOLD
♦ Knob setting #8: temperature is at 220º ; COOK
♦ Knob setting #10: temperature is at 300º ; PREHEAT
3.
Allow rollers to heat for 5 to 10 minutes before placing product on rollers.
4.
Plastic tongs are included with units with Silverstone or GripsIt rollers. Use plastic to prevent serious
damage to these rollers. Never use metal utensils or tools on the Silverstone or GripsIt rollers.
ELECTRICAL REQUIREMENTS
Refer to the product tag (serial plate) on the back of the unit for voltage and wattage requirements. Be sure to
plug unit into outlet with sufficient power.