Nemco Food Equipment Digital Roller Grills - Operations Manual - Manual

Model Series: 8230, 8250, Electronic Rollergrills
INTRODUCTION
1.
Please read instructions before using.
2. This roller grill will be HOT during use and for a short time after it is turned off – BE CAREFUL!
INSTALLATION
1. Set the roller grill on a flat surface.
2.
Position the roller grill near the power outlet. Avoid the use of extension cords.
3. Plug the roller grill into a certified electrical outlet with a corresponding voltage rating as listed on the
roller grill model label.
4.
Clean the roller grill thoroughly before use.
OVERVIEW OF CONTROLS
1.
There is a lighted rocker switch to turn the roller grill on.
2. There are two zone buttons (front and rear) which are also used as up and down buttons during the
settings mode.
3.
There are a set of four indicator lights for each zone to indicate which phase of the cook cycle that zone is
currently in (preheat, cook, hold – below 160°F, and hold – above 160°F)
4. There is also a display that shows either the time left before the product is ready to serve, or the
temperature of the zone when the product is ready to serve.
5.
There are two indicator lights by the zone buttons to show which zone the display is currently showing.
OPERATION
1.
Turn the switch on to turn the roller grill on. The lights will all flash when the controls power up and the
rocker switch will then light up.
2.
The display shows dashes to indicate that no heat cycle is active. At this point the product can be placed
on the rollers and the appropriate zone button (front or rear) can be pressed to initiate the cook cycle for
that zone. The front and rear of the grill are denoted by the two different colors of roller end seals; black
for front, white for rear.
3.
After pressing the zone button, the roller grill will begin a 10 minute preheat phase which is designed to
be part of the cook cycle. It will then automatically adjust the temperature for the cook phase. Once the
grill completes the cook phase, it will automatically adjust the temperature for the hold phase.
4.
During the cook phase, the grill will display how much time is left before the product is ready (all times
are in hours and minutes). Once the product is ready, the display changes to show the temperature of the
product. At this point the product is ready to serve. Once the holding time has expired, the hold light will
begin to flash to indicate that the food is beyond it’s recommended holding time.
Note: The roller grill will turn on the appropriate indicator light to indicate which phase it is in (preheat,
cook hold).
5.
When both zones are in operation, the display of the grill will cycle from the front zone to the rear zone to
display the status of each. To see the status of a zone immediately, tap that zone’s button and the display
will change to show its status.
6.
If product has been used up, and the hold cycle needs cancelled, press and hold the appropriate zone
button (front or rear). The hold light will then turn off to indicate that the zone is no longer heating.
7.
Also, the operator can skip the preheat cycle once it is initiated by pressing and holding the zone button
(front or rear). The same can be done with the cook cycle.