Moog Music Little Phatty Stage II - Manual (Page 30)

Page 32
LP Stage II User’s Manual - The User Interface
Page 33
LP Stage II User’s Manual - The User Interface
MIDI SETUP (con’t)
The fifth page of the MIDI Setup menu allows you to select the routing
of the MIDI Merge function for the USB input. When MIDI Merge is
ON, the LP will echo all MIDI data received at the USB MIDI Input port
to the selected MIDI Output port, merged with any MIDI data generat-
ed by the LP. This allows you to pass MIDI data thru the LP, even though
the LP has no dedicated MIDI Thru connector. To change the selected
MIDI output port, use the CURSOR to highlight the output parameter,
then use the VALUE knob to select the desired output.
Values: NONE, DIN OUT, USB OUT, DIN/USB OUT;
the default is NONE.
The fourth page of the MIDI Setup menu allows you to select the MIDI
output connection. To specify the MIDI output connection, use the
CURSOR button to highlight the output selection, then use the VALUE
knob to select the new output.
Values: NONE, DIN, USB, DIN/USB; the default is DIN/USB
NOTE: When using MIDI Merge, take precautions to insure that you do not create a MIDI feedback
loop (the output is passed back into the input and then merged with the output again), or you may
experience unwanted side effects like a locked-up LP. Should this happen, cycling the power should
resolve the condition, but it is best not to create a MIDI feedback loop in the first place.
The sixth page of the MIDI Setup menu allows you to select the rout-
ing of the MIDI Merge function for the DIN input. When MIDI Merge
is ON, the LP will echo all MIDI data received at the MIDI DIN Input
port to the selected MIDI Output port, merged with any MIDI data
generated by the LP. To change the selected MIDI output port, use the
CURSOR to highlight the output parameter, then use the VALUE knob
to select the desired output.
Values: NONE, DIN OUT, USB OUT, DIN/USB OUT;
the default is NONE.