Moog Music Etherwave Plus Kit (Upgrade Instructions) User Manual
Page 4
Installing the Upgrade
This part of the installation requires soldering. Before you begin, you will need to have your soldering iron powered
up and at an appropriate soldering temperature.
1) Select the 5-wire harness. Make the following solder connections to the 11-211 PCB (shown in figure 4):
Yellow
to
AUDIO
Orange
to
AMP OUT
Red
to
AMP IN
Brown
to
VCA OUT
figure 4
2) Solder the Black wire of the 5-pin harness to the #6 locking terminal (see figure 4). Trim any excess leads of the
other four wires on the bottom of the PCB.
3) Reinstall the 11-211 Etherwave Circuit board and solder the antenna wires to the PCB antenna connectors.
4) Excluding the Grey and White wires, strip the wires of the 10-wire harness to expose 3/16” of bare wire and tin
them. Make sure there is not excess solder built up on the wires, or they will not be easy to install in the 11-213
PCB.
5) With the 8 stripped and tinned wires of the 10-wire harness, Make the following solder connections to the 12-213
PCB (as shown in figure 5):
Black
to
J1-1 (square pad, closest to center of PCB)
Green
to
J1-2
Blue
to
J1-3
Violet
to
J1-4
Red
to
J1-5
Orange
to
J1-6
Brown
to
J1-7
Yellow
to
J1-8
6) Insert the LED through the LED spacer. Install the LED into the non-component side of the 11-213 with the long
lead inserted into the square pad (closest to center of PCB; shown in figure 5). Solder the LED in place and trim
the excess leads.