Moog Music Etherwave Plus Kit (Upgrade Instructions) User Manual
Page 6
10) Slowly place the panel onto the front of the cabinet so the potentiometer leads stick through the
appropriate pads on the 11-213 PCB (shown in figure 7).
11) Holding the panel in place, flip the unit over and install the three screws that fasten the panel to the bottom of
the cabinet.
12) Reinstall the mic stand adapter.
13) Turn the unit over. Solder the pot leads to the PCB.
14) Make the following connections (final result shown in figure 8):
5-wire harness connector
to
11-213 PCB connector labeled J2
10-wire connector
to
11-211 PCB connector labeled CN1
#6 locking terminal
to
Foil strip (screw terminal down)
Phones Out
to
11-213 PCB connector labeled J7
Audio Out
to
11-213 PCB connector labeled J8
Grey/white wires
to
Power switch terminals
figure 7
figure 8
15) Turn the pots all the way down (full CCW). Install the knobs so the indicators point to 7:00.