Cobalt Digital COMPASS 9275 HD_SD-SDI Analog Audio De-Embedder - Manual (Page 20)

3-2 •••• User Controls 9275-4C / 9275-8C User Manual •••• (V 1.2)
Card Overview
This section provides a general overview of the 9275 components. The configurations outlined in
this section should be performed before installing the card in the frame, but may be repeated as
required. For information on the LEDs available on the card-edge, refer to the section “Control
and Monitoring Features”.
Figure 3.1 9275 —Card-edge Components
1) Function Select Switch (SW2) 2) Mode Select Switch (SW3) 3) Bootload Button (SW1)
1. Function Select Switch (SW2)
Use SW2 to select general operation functions and menu items and works in conjunction with
the Mode Select Switch ( SW3 ).
2. Mode Select Switch (SW3)
Use SW3 to enable, disable, and select specific configurations within the operational function
modes menu (selected first with SW2 ).
4. Bootload Button (SW1)
SW1 is used for factory service in the unlikely event of a complete card failure. Do not press
this button unless instructed to do so by Cobalt Technical Support personnel.
For More Information...
• on using the SW2 and SW3 switches, refer to the section “Card-edge Menu
System”.
• on the LEDs located on the card-edge, refer to the section “Status and Selection
LEDs on the 9275”.