Introduction, 9501-dcda functional description – Cobalt Digital OBSIDIAN 3G 9501-DCDA-3G Downconverter User Manual
Page 15
9501DCDA-OM (V1.3)
9501-DCDA PRODUCT MANUAL
1-11
Introduction
9501-DCDA Functional Description
Figure 1-4 9501-DCDA User Control Interface
Note:
If network remote control is to be used for the frame and the frame has not yet
been set up for remote control, Cobalt
®
reference guide Remote Control
User Guide (PN 9000RCS-RM) provides thorough information and
step-by-step instructions for setting up network remote control of Cobalt
®
cards using DashBoard™. (Cobalt
®
OGCP-9000 and OGCP-9000/CC
Remote Control Panel product manuals have complete instructions for setting
up remote control using a Remote Control Panel.)
Download a copy of this guide by clicking on the Support>Reference
Documentlink at www.cobaltdigital.com and then select DashBoard
Remote Control Setup Guide as a download, or contact Cobalt
as listed in
Contact Cobalt Digital Inc. (p. 1-15).
Computer
with NIC
OGCP-9000 Control Panel
or
OGCP-9000/CC Control Panel
20-Slot Frame with Network Controller Card
LAN
9501-DCDA Card
In conjunction with a frame equipped
with a Network Controller Card,
9501-DCDA card can be remotely
controlled over a LAN
Remote Control Panel
Using the Control Panel,
9501-DCDA card can be remotely
controlled over a LAN
DashBoard™ Remote Control
Using a computer with
DashBoard™ installed,
9501-DCDA card can be
remotely controlled over a LAN
Note: • To communicate with DashBoard™ or a Remote Control Panel, the frame must have the optional MFC-8320-N
network controller card installed.
• DashBoard™ and the Remote Control Panels provide network control of the 9501-DCDA as shown. The value
displayed at any time on the card, or via DashBoard™ or a Control Panel is the actual value as set on the card, with
the current value displayed being the actual value as effected by the card. Parameter changes made by any of these
means are universally accepted by the card (for example, a change made using the DashBoard™ controls will
change the setting displayed on a Control Panel).