Cobalt Digital OBSIDIAN 3G 9501-DCDA-3G Downconverter - Manual (Page 52)

3
9501-DCDA Function Submenu List and Descriptions
3-24 9501-DCDA PRODUCT MANUAL 9501DCDA-OM (V1.3)
Provides an audio crosspoint allowing the audio source
selection for each analog audio output channel. Also
provides Gain, Phase Invert, and Muting controls and
peak level meters for each output channel.
• Analog Output Channel Source Using the Source drop-down list, selects the audio input source to be
routed to the corresponding analog audio output channel from the
following choices:
• Embedded input channel 1 thru 16 (Emb Ch 1 thru Emb Ch 16)
• Built-in Tone generators Tone 1 thru Tone 16
(all are -20 dBFS level; freq (Hz) in ascending order are 100, 200, 300,
400, 500, 600, 700, 800, 900, 1k, 2k, 4k, 6k, 8k, 12k, and 16k)
• Audio LTC
• Downmixer L
• Downmixer R
Note: Although DashBoard controls for de-embedding to analog out
channels AN Out Ch 1 thru AN Out Ch 8 are present, current rear
modules allow only AN Out Ch 1 thru AN Out Ch 4 to be used.
• Channel Mute/Phase Invert/Gain Controls
and Peak Level Display
Provides Mute and phase Invert channel controls, as well as peak level
meter for each output channel. (Meter shows level as affected by Level
control.)
Gain controls allow relative gain (in dB) control for each corresponding
destination analog audio out channel.
(-80 to +20 dB range in 1.0 dB steps; unity = 0 dB)
Table 3-2 9501-DCDA Function Submenu List — continued