TC Electronic BG250-210 - Manual (Page 14)

Operation – Front Panel
10
1. INPUT
You can connect an active or passive bass to this ¼”
input jack. The input stage of your bass combo is de-
signed to adapt to any type of pickup.
2. GAIN knob and CLIP LED
The input gain should be set to the highest possible lev-
el without overloading the input stage. To find the cor-
rect setting, simply plug in your bass, play and turn up
the GAIN knob until the PEAK LED occasionally lights
up. Then reduce the gain slightly. When set, simply turn
up the MASTER volume knob to start playing.
3. DYNAMIC TONE CONTOURING
FILTER SECTION
The Dynamic Tone Contouring Filter Section of this
TC bass combo is not your standard bass amp EQ!
Ordinary bass, middle and treble controls boost or cut
the same frequency area when you turn the controls
clockwise or counterclockwise. The tone controls of
a BG250-112, BG250-115 or BG250-210 intelligently
address several different frequencies when you turn
them, integrating not only tone control but also contour-
ing your sound.
By adapting one or more target frequencies and band-
widths at the turn of a single knob, the Dynamic Tone
Contouring Filter Section combines excellent tone
shaping abilities with ease of use.
4. TONEPRINT buttons
and control knobs A & B
TonePrints are described on page 10 of this manu-
al.
If you are not familiar with the concept, please
read this section first. You can also find additional
information and videos about TonePrint technology on
TC’s website.
Your BG250-112, BG250-115 or BG250-210 bass
combo can store two independent TonePrints. To
select a TonePrint slot (A or B), press the button right
under the label A or B.