TC Electronic Shaker Vibrato User Manual
Page 11
11
Buffered Bypass – If you use a long cable between your guitar and the first pedal; if you use many
pedals on your board and if you use a long cable from your board to the amp, then the best solution
will most likely be to activate the buffer in the first and last pedal of the signal chain. Can you hear the
difference between a pedal in True Bypass or Buffered Bypass? Maybe, maybe not, – many factors
apply. Active/passive pick-ups, single coil/humbucker, cable quality, amp impedance and more. We
cannot give a single ultimate answer. Use your ears and find the best solution for your setup!
Changing battery – Unscrew the thumb-screw on the back of the pedal and detach the back-plate.
Unmount the old battery and attach the new battery to the battery clip making sure the polarity is
correct. Then remount the back-plate. To save battery life, remove the input jack when you don’t play.
Batteries must never be heated, taken apart or thrown into fire or water. Only rechargeable
batteries can be recharged. Remove the battery when the pedal is not being used for a longer
period of time. Dispose batteries according to local laws and regulations.