TC Electronic TonePrint Editor - Manual (Page 17)

■
Reverb parameters
TC Electronic TonePrint Editor ■ Manual for software version 1 .0 15
Reverb parameters
Use the parameters in the Reverb section of the
TonePrint Editor window to configure the reverb
effect .
Decay parameter
Parameter range: 0 .01 to 20 s
Use the Decay parameter to set the decay time of
the Reverb in seconds . The decay time is usually
associated with the time it takes the diffuse field
of a reverb to decay to -60 dB .
PreDelayShort parameter
Parameter range: 0 to 100 ms
The PreDelayShort parameter is only applicable
when the Pre-Delay switch on the pedal has been
set to the “Short” setting .
Use the PreDelayShort parameter to define a
short delay placed between the direct signal and
the Reverb’s diffuse field . Use the PreDelayShort
parameter to keep the source material clear and
undisturbed from the scattered diffuse field of the
Reverb arriving shortly after .
PreDelayLong parameter
Parameter range: 0 to 100 ms
The PreDelayLong parameter is only applicable
when the Pre-Delay switch on the pedal has been
set to the “Long” setting .
Use the PreDelayLong parameter to define a
short Delay placed between the direct signal and
the Reverb’s diffuse field . Use the PreDelayLong
parameter to keep the source material clear and
undisturbed from the scattered diffuse field of the
Reverb arriving shortly after .
Diffuse parameter
Parameter range: -50 to 50
Use the Diffuse parameter to fine-tune the density
of the reverb’s diffuse field . It allows you to reduce
flutter in the diffuse field to an absolute minimum .
LoColor parameter
Parameter range: -50 to 50
Use the LoColor parameter to adjust the low fre-
quency spectrum of the output signal . This can be
used for altering the overall color of the reverb .
HiColor parameter
Parameter range: -50 to 50
Use the HiColor parameter to adjust the high fre-
quency spectrum of the output signal . This can be
used for altering the overall color of the reverb .
HiFactor parameter
Parameter range: -25 to 25
Use the HiFactor parameter to emphasize or at-
tenuate the selected HiColor value .
Mod On/Off parameter
Use the Mod On/Off parameter to switch modula-
tion of the reverb signal on or off .
The algorithm designers at TC have adjusted the
diffuse field part of the reverb to be as smooth
and natural sounding as possible . Adding in mod-
ulation to the reverb tail allows for interesting ef-
fects that can be refined using the Modulation
Rate and Modulation Depth parameters .
Modulation Rate parameter
Parameter range: -25 to 25
Use the Modulation Rate parameter to offset the
speed of the LFO that is being used to modulate
the Reverb .
This parameter only has an effect when you have
set the Mod On/Off switch to On .
Modulation Depth parameter
Parameter range: -25 to 25
Use the Modulation Depth parameter to offset the
intensity of the modulation that is applied to the
reverb .
This parameter only has an effect when you have
set the Mod On/Off switch to On .