TC Electronic BH500 - Manual (Page 14)

12
operatIon – rear panel
MAINS IN – Power Input & POWER Switch
Make sure that the voltage of the power grid you are connecting
to matches the version of the BH500 you are using.
The 115V model can handle voltages between 100 V and 120 V.
The 230V model can handle voltages between 220 V and 240 V.
The ground pin of the power supply unit must be
connected in order to avoid voltage differences between
e.g. the PA and the BH500.
SPEAKER OUT
Use the SPEAKER OUT connector for connecting the BH500
to your speaker cabinets. The type of plug is Speakon and you
MUST use speaker cables. Do NOT use instrument cables!
TC Electronic Bass cabinets
• BH500 can run any combination of up to three TC Electronic
8 Ohm cabinets.
• Where a TC Electronic 4 Ohm cabinet is used, the following
configurations can be used:
1 x 4 Ohm
2 x 4 Ohm
1 x 4 Ohm + 1 x 8 Ohm
1 x 4 Ohm + 2 x 8 Ohm
Other Brand cabinets
1 x 4 Ohm
1 x 8 Ohm
2 x 8 Ohm
For additional information please refer to our speaker
configuration guide at:
www.tcelectronic.com/cabconfig