Rainbow Electronics MAXQ7670 - Manual (Page 5)

MAXQ7670
Microcontroller with 10-Bit ADC,
PGA, 64KB Flash, and CAN Interface
_______________________________________________________________________________________ 5
ELECTRICAL CHARACTERISTICS (continued)
(V DVDDIO = +5.0V, V AVDD = +3.3V, V DVDD = +2.5V, V REFADC = +3.3V, system clock = 16MHz. T A = T MIN to T MAX , unless otherwise
noted. Typical values are at T A = +25°C.) (Note 1)
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS
Output Current Capability LRAPD = 0 50 mA
Output Short-Circuit Current LRAPD = 0, AVDD shorted to AGND 100 mA
Maximum AVDD Bypass
Capacitor to AGND
LRAPD = 0 0.47 µF
+2.5V (DVDD) LINEAR REGULATOR
DVDD Output Voltage REGEN2 = GNDIO 2.38 2.5 2.62 V
No-Load Quiescent Current
REGEN2 = GNDIO, all internal digital
peripherals disabled
15 µA
Output Current Capability REGEN2 = GNDIO 50 mA
Output Short-Circuit Current
REGEN2 = GNDIO, DV
DD shorted to
DGND
100 mA
Maximum DVDD Bypass
Capacitor to DGND
REGEN2 = GNDIO 0.47 µF
SUPPLY-VOLTAGE SUPERVISORS AND BROWNOUT DETECTION
DVDD Reset Threshold
Asserts RESET if V DVDD is below this
threshold
2.1 2.25 V
DVDD Interrupt Threshold
Generates an interrupt if V DVDD falls
below this threshold
2.25 2.38 V
Minimum DVDD Interrupt and
Reset Threshold Difference
0.14 V
AVDD Interrupt Threshold
Generates an interrupt if V AVDD falls
below this threshold
3.0 3.15 V
DVDDIO Interrupt Threshold
Generates an interrupt if V DVDDIO
falls below this threshold
4.5 4.75 V
DV DD 1 2.75
AV DD 1 3.6 Operational Range
DV DDIO 1 5.25
V
Supervisor Hysteresis ±0.7 %
CAN INTERFACE
CAN Baud Rate f CANCLK = 8MHz 1 Mbps
CANCLK Mean Frequency
Error 8MHz or 16MHz, 50ppm external
crystal
60 ppm
CANCLK Total Frequency Error
8MHz or 16MHz, 50ppm external
crystal; measured over a 12ms
interval; mean plus peak cycle jitter
< 0.5 %