Rainbow Electronics GM862-QUAD-PY - Manual (Page 46)

Easy GPRS User Guide
80000ST10028 Rev. 4 - 16/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 46 of 63
3.2 Commands overview
This paragraph describes the configuration and the activation of the GSM context and the new AT
commands implemented to facilitate the use of Easy GSM and Easy GPRS in the same device.
For more information about concerning outgoing and incoming connections, you can refer to the
chapter “Enhanced Easy GPRS Extension“: there are no differences at sockets level.
NOTE: For more detailed AT commands and parameters definitions consult the AT Commands
Reference Guide.
3.2.1 Configuring GSM access
GSM context definition differs from GPRS one and requires a new command: #GSMCONT, that
replaces, just in GSM case, the standard +CGDCONT. The only parameter to set is the number of the
Internet Service Provider. The command syntax is:
AT#GSMCONT=0, “IP“, <CSD num>
Where
• 0 is the context identifier for the GSM context
• CSD num is the Internet Service Provider number