Analog to digital converter, Features, Atmega169v/l – Rainbow Electronics Atmega169L User Manual

Page 191

Advertising
background image

191

ATmega169V/L

2514A–AVR–08/02

Analog to Digital
Converter

Features

•

10-bit Resolution

•

0.5 LSB Integral Non-linearity

•

± 2 LSB Absolute Accuracy

•

TBD - 260 µs Conversion Time

•

Up to TBD kSPS at Maximum Resolution

•

Eight Multiplexed Single Ended Input Channels

•

Seven Differential input channels

•

Optional Left Adjustment for ADC Result Readout

•

0 - V

CC

ADC Input Voltage Range

•

Selectable 1.1V ADC Reference Voltage

•

Free Running or Single Conversion Mode

•

ADC Start Conversion by Auto Triggering on Interrupt Sources

•

Interrupt on ADC Conversion Complete

•

Sleep Mode Noise Canceler

The ATmega169 features a 10-bit successive approximation ADC. The ADC is con-
nected to an 8-channel Analog Multiplexer which allows eight single-ended voltage
inputs constructed from the pins of Port A. The single-ended voltage inputs refer to 0V
(GND).

The device also supports 16 differential voltage input combinations. Seven differential
analog input channels share a common negative terminal (ADC1), while any other ADC
input can be selected as the positive input terminal.

The ADC contains a Sample and Hold circuit which ensures that the input voltage to the
ADC is held at a constant level during conversion. A block diagram of the ADC is shown
in Figure 82.

The ADC has a separate analog supply voltage pin, AVCC. AVCC must not differ more
than ± 0.3V from V

CC

. See the paragraph “ADC Noise Canceler” on page 198 on how to

connect this pin.

Internal reference voltages of nominally 1.1V or AVCC are provided On-chip. The volt-
age reference may be externally decoupled at the AREF pin by a capacitor for better
noise performance.

Advertising