16-bit timer/counter1 with pwm, 1 overview – Rainbow Electronics ATmega64C1 User Manual

Page 106

Advertising
background image

106

7647A–AVR–02/08

ATmega32/64/M1/C1

13. 16-bit Timer/Counter1 with PWM

The 16-bit Timer/Counter unit allows accurate program execution timing (event management),
wave generation, and signal timing measurement. The main features are:

•

True 16-bit Design (i.e., Allows 16-bit PWM)

•

Two independent Output Compare Units

•

Double Buffered Output Compare Registers

•

One Input Capture Unit

•

Input Capture Noise Canceler

•

Retriggering Function by External Signal (ICP1A or ICP1B)

•

Clear Timer on Compare Match (Auto Reload)

•

Glitch-free, Phase Correct Pulse Width Modulator (PWM)

•

Variable PWM Period

•

Frequency Generator

•

External Event Counter

•

Four independent interrupt Sources (TOV1, OCF1A, OCF1B, and ICF1)

13.1

Overview

Most register and bit references in this section are written in general form. A lower case “n”
replaces the Timer/Counter number, and a lower case “x” replaces the Output Compare unit
channel. However, when using the register or bit defines in a program, the precise form must be
used, i.e., TCNT1 for accessing Timer/Counter1 counter value and so on.

A simplified block diagram of the 16-bit Timer/Counter is shown in

Figure 13-1

. For the actual

placement of I/O pins, refer to

“Pin Descriptions” on page 5

. CPU accessible I/O Registers,

including I/O bits and I/O pins, are shown in bold. The device-specific I/O Register and bit loca-
tions are listed in the

“16-bit Timer/Counter Register Description” on page 126

.

The PRTIM1 bit in

“Power Reduction Register” on page 41

must be written to zero to enable

Timer/Counter1 module.

Advertising