Preventing eeprom corruption, Attiny15l – Rainbow Electronics ATtiny15L User Manual

Page 38

Advertising
background image

38

ATtiny15L

1187E–AVR–06/02

The user should poll the EEWE bit before starting the read operation. If a write operation
is in progress when new data or address is written to the EEPROM I/O Registers, the
write operation will be interrupted and the result is undefined.

The calibrated oscillator is used to time EEPROM. In Table 16 the typical programming
time is listed for EEPROM access from the CPU.

Preventing EEPROM
Corruption

During periods of low V

CC

, the EEPROM data can be corrupted because the supply volt-

age is too low for the CPU and the EEPROM to operate properly. These issues are the
same as for board-level systems using the EEPROM and the same design solutions
should be applied.

An EEPROM data corruption can be caused by two situations when the voltage is too
low. First, a regular write sequence to the EEPROM requires a minimum voltage to
operate correctly. Second, the CPU itself can execute instructions incorrectly if the sup-
ply voltage for executing instructions is too low.

EEPROM data corruption can easily be avoided by following these design recommen-
dations (one is sufficient):

1.

Keep the AVR RESET active (low) during periods of insufficient power supply
voltage. This can be done by enabling the internal Brown-out Detector (BOD) if
the operating voltage matches the detection level. If not, an external low V

CC

Reset Protection circuit can be applied.

2.

Keep the AVR core in Power-down sleep mode during periods of low V

CC

. This

will prevent the CPU from attempting to decode and execute instructions, effec-
tively protecting the EEPROM Registers from unintentional writes.

3.

Store constants in Flash memory if the ability to change memory contents from
software is not required. Flash memory cannot be updated by the CPU and will
not be subject to corruption.

Table 16. Typical EEPROM Programming Times

Parameter

Number of Calibrated RC

Oscillator Cycles

Min Programming

Time

Max Programming

Time

EEPROM write
(from CPU)

8192

4.6 ms

8.2 ms

Advertising