Rainbow Electronics GM862-QUAD-PY - Manual (Page 63)

GM862-QUAD / PY Hardware User Guide
1vv0300748 Rev. 5 - 20/09/07
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 63 of 68
13 Mounting the GM862 Modules on your
Board
In order to electrically connect your board to the Telit GM862-QUAD/PY modules, use a CSTP 2x25 pin
vertical SMD SCH–SCH Molex 53748 - 0504 (female, low profile) as a counterpart to the CSTP 50
pin vertical SMD Molex 52991–0508 (male) of your
Telit GM862-QUAD/PY modules .
When mounting the Telit GM862-QUAD/PY modules on your board, take care of soldering the GM862
shielding reeds on a ground plane or signal.
Molex 53748-0504 (female, low profile) Connector LAY-OUT