Bit timer/counter1, Overview – Rainbow Electronics ATmega3290P_V User Manual

Page 105

Advertising
background image

105

ATmega329/3290/649/6490

2552H–AVR–11/06

16-bit
Timer/Counter1

The 16-bit Timer/Counter unit allows accurate program execution timing (event man-
agement), wave generation, and signal timing measurement. The main features are:
•

True 16-bit Design (i.e., Allows 16-bit PWM)

•

Two independent Output Compare Units

•

Double Buffered Output Compare Registers

•

One Input Capture Unit

•

Input Capture Noise Canceler

•

Clear Timer on Compare Match (Auto Reload)

•

Glitch-free, Phase Correct Pulse Width Modulator (PWM)

•

Variable PWM Period

•

Frequency Generator

•

External Event Counter

•

Four independent interrupt Sources (TOV1, OCF1A, OCF1B, and ICF1)

Overview

Most register and bit references in this section are written in general form. A lower case
“n” replaces the Timer/Counter number, and a lower case “x” replaces the Output Com-
pare unit. However, when using the register or bit defines in a program, the precise form
must be used, i.e., TCNT1 for accessing Timer/Counter1 counter value and so on.

A simplified block diagram of the 16-bit Timer/Counter is shown in Figure 41. For the
actual placement of I/O pins, refer to “Pinout ATmega3290/6490” on page 2. CPU
accessible I/O Registers, including I/O bits and I/O pins, are shown in bold. The device-
specific I/O Register and bit locations are listed in the “16-bit Timer/Counter Register
Description” on page 126.

The PRTIM1 bit in “Power Reduction Register” on page 35 must be written to zero to
enable the Timer/Counter1 module.

Advertising