Analog to digital converter, Features – Rainbow Electronics ATmega3290P_V User Manual

Page 203

Advertising
background image

203

ATmega329/3290/649/6490

2552H–AVR–11/06

Analog to Digital
Converter

Features

•

10-bit Resolution

•

0.5 LSB Integral Non-linearity

•

± 2 LSB Absolute Accuracy

•

13 µs - 260 µs Conversion Time (50 kHz to 1 MHz ADC clock)

•

Up to 76.9 kSPS at Maximum Resolution (200 kHz ADC clock)

•

Eight Multiplexed Single Ended Input Channels

•

Optional Left Adjustment for ADC Result Readout

•

0 - V

CC

ADC Input Voltage Range

•

Selectable 1.1V ADC Reference Voltage

•

Free Running or Single Conversion Mode

•

ADC Start Conversion by Auto Triggering on Interrupt Sources

•

Interrupt on ADC Conversion Complete

•

Sleep Mode Noise Canceler

The ATmega329/3290/649/6490 features a 10-bit successive approximation ADC. The
ADC is connected to an 8-channel Analog Multiplexer which allows eight single-ended
voltage inputs constructed from the pins of Port F. The single-ended voltage inputs refer
to 0V (GND).

The ADC contains a Sample and Hold circuit which ensures that the input voltage to the
ADC is held at a constant level during conversion. A block diagram of the ADC is shown
in Figure 84.

The ADC has a separate analog supply voltage pin, AVCC. AV

CC

must not differ more

than ± 0.3V from V

CC

. See the paragraph “ADC Noise Canceler” on page 209 on how to

connect this pin.

Internal reference voltages of nominally 1.1V or AVCC are provided On-chip. The volt-
age reference may be externally decoupled at the AREF pin by a capacitor for better
noise performance.

The PRADC, in “Power Reduction Register - PRR” on page 35 must be written to zero
to enable the ADC module.

Advertising