Note 3), Ac electrical characteristics – Rainbow Electronics LM96000 User Manual
Page 6
AC Electrical Characteristics
(Continued)
The following specifications apply for V+ = 3.0V to 3.6V unless otherwise specified in conditions. Boldface limits apply for T
A
= T
J
over T
MIN
=0˚C to T
MAX
=85˚C; all other limits T
A
=T
J
= 25˚C.
Symbol
Parameter
Conditions
Typical
Limits
Units
(Limits)
f
BUF
SMBus Free Time Between Stop And
Start Condition
4.7
µs (min)
t
HD_STA
Hold Time After (Repeated) Start
Condition (after this period, the first
clock is generated)
4.0
µs (min)
t
SU:STA
Repeated Start Condition Setup Time
4.7
µs (min)
t
SU:STO
Stop Condition Setup Time
4.0
µs (min)
t
HD:DAT
Data Output Hold Time
300
ns (min)
930
ns (max)
t
SU:DAT
Data Input Setup Time
250
ns (min)
t
TIMEOUT
Data And Clock Low Time To Reset
Of SMBus Interface Logic(Note 14)
25
35
ms (min)
ms (max)
t
LOW
Clock Low Period
4.7
µs (min)
t
HIGH
Clock High Period
4.0
50
µs (min)
µs (max)
t
F
Clock/Data Fall Time
300
ns (max)
t
R
Clock/Data Rise Time
1000
ns (max)
t
POR
Time from Power-On-Reset to
LM96000 Reset and Operational
V+
>
2.8V
500
ms (max)
20084603
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device is
functional, but do not guarantee specific performance limits. For guaranteed specifications and test conditions, see the Electrical Characteristics. The guaranteed
specifications apply only for the test conditions listed. Some performance characteristics may degrade when the device is not operated under the listed test
conditions.
Note 2: All voltages are measured with respect to GND, unless otherwise noted.
Note 3: When the input voltage (V
IN
) at any pin exceeds the power supplies (V
IN
<
GND or V
IN
>
V+ ), the current at that pin should be limited to 5mA. The 20mA
maximum package input current rating limits the number of pins that can safely exceed the power supplies with an input current of 5mA to four. Parasitic components
and/or ESD protection circuitry are shown below for the LM96000’s pins. The nominal breakdown voltage the zener is 6.5V. Care should be taken not to forward bias
the parasitic diode D1 present on pins D+ and D−. Doing so by more that 50 mV may corrupt temperature measurements. SNP stands for snap-back device.
LM96000
www.national.com
6