Yamaha DG60-112 - Manual (Page 5)

5
● Avoid using your amplifier in the following locations to prevent
possible damage:
• In direct sunlight or next to heating equipment.
• Extremely cold or hot locations.
• Locations exposed to high humidity or excessive dust.
• Locations subject to strong shocks or vibration.
● Before making any connections, make sure that the power on the
amplifier and any external devices is switched OFF.
● To protect the speaker from possible damage, always set the
MASTER knob to “0” before switching the power ON/OFF.
● When connecting a speaker to this unit make sure to turn OFF
the power first.
● Do not apply excessive force to the switches and controls.
● Your Yamaha guitar amplifier is a precision musical instrument.
Handle it with care and avoid dropping or bumping it.
Precautions
● Operating temperatures will rise during use. Make sure the
amplifier is used in a well-ventilated area. The DG60-112 should
be placed in a position were there is at least 30cm (12”) clear-
ance from the wall on the sides, top and back of the amplifier.
● For safety, always remove the power plug from the AC wall
outlet if there is any danger of lightning striking in your area.
● Keep the amplifier away from neon signs or fluorescent lighting
to prevent noise pickup.
● To prevent damage and possibly electrical shock, never open the
case and tamper with the internal circuitry.
● Never use benzene, thinner or other volatile liquids for cleaning,
as these chemicals may cause damage or discoloration to the
finish. Always use a dry, soft cloth to wipe off dust and dirt.
Digital Section
Complete Digital Signal Processing
Amplification Type : Internal 8 Channel Preset
Digital Reverb (SPRING)
Speaker Simulator (LINE OUT)
Analog Section
60W Solid State Power Amp
30 cm Speaker (EMINENCE) x 1
Controller/Switch
Front Panel : GAIN, MASTER, TREBLE, HIGH MID, LOW MID,
BASS, PRESENCE, REVERB, AMP select switch, for each
channel (A/B), Channel select switch (A/B)
Rear Panel : EFFECT BLEND, SP MUTE switch, for each
channel (A/B), EFFECT SEND/RETURN level switch
Indicator
Peak Level Display LED (Red)
Connection Jacks
INPUT HIGH/LOW, EFFECT SEND/RETURN, LINE OUT/
PHONES, FOOT SW (CH SELECT, REVERB)
: All Standard Phone Mono Jack
A/D Converter 20 bit + 3 bit floating
D/A Converter 20 bit
Sampling Frequency 48 kHz
Input Level/Impedance
INPUT HIGH: –20dBm (THRU)/1M
Ω
INPUT LOW: –10dBm (THRU)/1M
Ω
EFFECT RETURN: 0dBm/120k
Ω
Output Level/Impedance
SPEAKER: 60W RMS/8
Ω
LINE OUT: +2dBm/47 Ω
EFFECT SEND: –2dBm/1k
Ω
Power Requirements
U.S. and Canadian models : 120V, 60Hz
General model : 230V, 50Hz
Power Consumption
70W
Dimensions (W x H x D)
540 x 504 x 276 mm (21.3” x 19.8” x 10.9”)
Weight
18.0 kg (39 lbs 11 oz)
Specifications
* Specifications and external appearance are subject to change without notice.