B&B Electronics 516TX-A - Manual - Manual (Page 17)

(Revised 8/4/2009) 17
Logging In (password protection)
Access using the CLI is password-protected. You can log in as administrator to read and modify the 500
Series switch parameters. Note: The factory defaults admin password is admin.
First press <Escape> to access the Management Console Function.
Login:
enter username ‘admin’ and then press <Enter>.
Password: enter password ‘admin’, then press <Enter>.
(see section on user defined password)
Example:
Managing IGMP Snooping.....................
Exit to return to Management Console Function.
Press [ESC] to Exit >
** Now in user interface mode. **
** IGMP Snooping will resume after power is cycled. **
Login - (Enter Username)> admin
Username is correct.
Login continued - (Enter Password)> *****
Password is correct.
CUSTOMER USER VALIDATED.
/ (Go to top of menu tree)
? (Show menus/commands)
info (Show identification data)
SYSTEM (Open system menu)
SWITCH (Open switch menu)
CLI>
You can now activate the commands of the CLI.