B&B Electronics ZXT9-RM-KIT - Manual - Manual (Page 53)

Document Number: pnZXTxRM-0712m
Page
53
A1 – End Device Association: Set/read End Device association
options. Options enabled when bits are set: bit3 - Poll coordinator on pin
wake, bit2 - Auto Associate, bit1 - Allow Channel reassignment, bit0 -
Allow PanId reassignment. This is a pull down option. Selections are:
0
– 0000b
1 – 0001b
2 – 0010b
3 – 0011b
4 – 0100b
5 – 0101b
6 – 0110b
7 – 0111b
8 – 1000b
9 – 1001b
10 – 1010b
11 – 1011b
12 – 1100b
13 – 1101b
14 – 1110b
15 – 1111b
A2 – Coordinator Association: Set/read Coordinator association
options. Options enabled when bits are set: bit2 - Allow Association,
bit1 - Allow Channel reassignment, bit0 - Allow PanId reassignment.
This is a pull down option. Selections are:
0
– 000b
1 – 001b
2 – 010b
3 – 011b
4 – 100b
5 – 101b
6 – 110b
7 – 111b
RF Interfacing: Used to change RF interface options.
Figure 5-32 RF Interfacing (ZXT24-RM)