Dual Electronics XDMA6630 - Manual (Page 22)

22
Bluetooth
®
Operation
XDMA6630 OPERATION
Overview
The XDMA6630 supports the HFP (hands-free profile), A2DP (advanced audio distribution
profile) and AVRCP (audio video remote control profile).
Preparation
Before you can use a mobile device with this head unit, it must be paired and connected.
Please make sure that Bluetooth is activated on your mobile device before you begin the
pairing process. Refer to the owner's manual of your mobile device for more details.
Bluetooth Pairing
1) To pair a Bluetooth enabled mobile phone to your head unit, change to Bluetooth mode
by pressing on the head unit or press MODE until "BLUE-TOOTH" is displayed.
2) Press and hold on the head unit for 5 seconds, until "PAIRING" is displayed, the
Bluetooth icon will flash every second. The head unit will begin to broadcast the pairing
signal for 90 seconds.
3) Complete the pairing from the Bluetooth menu of your mobile device by searching
for new devices. Please refer to your mobile device instructions for further information
on Bluetooth pairing and connections. The Bluetooth icon will illuminate solid when
connected.
The BTM60 device name is "DUAL_BT"
The Bluetooth passcode "1234"
Compatibility
• Due to the differences in Bluetooth technology, some mobile devices may be
incompatible or function improperly when used with the XDMA6630.
Connecting a mobile device
• If the AUTO-CON menu setting is set to OFF, you must press to connect you device
after pairing.
• From Bluetooth standby mode, press and hold to disconnect your mobile device.
• If your mobile device becomes disconnected, press from Bluetooth standby mode to
reconnect your mobile device.
• To connect a previously paired mobile device:
1) Disconnect any mobile devices by pressing and holding for 5 seconds.
2) Press SELECT. "DEVICE NAME" will appear on the LCD.
2) Turn the volume knob to cycle through the list of devices 1 through 8.
3) Press to connect to the desired device. It must be in range to connect.
Note: When a device number is selected, i will take a few moments for the device name to
appear on the bottom line of the LCD.