Dual Electronics XDMA6630 - Manual (Page 23)

23
Bluetooth
®
Operation
XDMA6630 OPERATION
Function Description
Making a Phone Call
Press once. "Enter Number" will be shown, then an "_" will
appear on the display.
Input the desired phone number using the 0-9, *, # buttons on the
remote control. Press to begin dialing.
A phone call may also be placed from your mobile device using
the keypad, phone book or speed dial. When a call is placed from
a mobile device, “DIALING” will appear on the head unit display.
Receiving a Phone
Call
If an incoming call is detected, the head unit will automatically
switch to Bluetooth mode.
The incoming phone number will scroll across the display, the
phone icon will flash on the display, and a ring tone will be
audible from the vehicle speakers. See Bluetooth Settings for
speaker configurations.
Note: The ring audio level will depend the mobile device and head
unit ring volume and audio settings. If the ringer on the mobile
device is off, you may not hear an incoming ring tone.
Press on the head unit to receive a call. The phone icon in the
display will illuminate solid.
During a Phone Call
The head unit will display the elapsed time of the phone call.
The volume knob will adjust the volume of the call.
Press MUTE to mute the microphone during a call.
Refusing a Call
To refuse an incoming phone call, press and hold for 3
seconds.
Ending a Phone Call
Press to end a call.
If the phone call was received, the head unit will return to
previous mode when call is ended.
Redial Press twice consecutively to redial the last number.