BabyTrend HC01091 - TREND HIGH CHAIR - MESA - Manual (Page 3)

Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved. Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved.
IMPORTANT!
To ensure safe operation of your product,
please follow these instructions carefully. Please keep these
instructions for future reference.
IMPORTANT!
Before assembly and each use, inspect this
product for damaged hardware, loose joints, missing parts or sharp
edges. NEVER use if any parts are missing or broken.
IMPORTANT!
Adult assembly is required.
IMPORTANT!
Always check that the high chair is locked
in the open position before using.
ATTENTION:
Carefully remove parts from box. Check that you
have all the parts for this model before assembling
the high chair. NOTE: Certain High Chair models
are packaged with the High Chair Seat Fabric and
Seat Insert already attached to the Seat Back.
TO ASSEMBLE SEAT
1. Place the Seat Base on a flat surface as shown
in figure 1.
2. Join the Seat Back to the Seat Base using the
Seat Back Hinge Rod as shown in figure 2.
The rod is inserted from right to left as shown.
Fig. 1
ASSEMBLY ASSEMBLY
3 4
Fig. 4
Fig. 2
3. Slide the left and right sides’ Height Bracket
onto the Seat Base (Fig. 3). Snap the brackets
in place (Fig. 4).
4. Slide the Footrest onto the Seat Base as shown
in Figure 5. Snap Footrest into place.
5. Insert the front tube of the right side Upper
Frame Assembly into the Height Bracket
(Fig. 6). The front tube is easily distinguished
from the rear tube by the array of holes located
on the backside of the tube.
6. Squeeze the Red Release Handle and push the
tube through the Height Bracket until it locks
on the highest position (Fig. 7).
7. Repeat Steps 5 and 6 for the left side Upper
Frame Assembly (Fig. 8).
Fig. 3
Fig. 5
Seat Back
Seat Base
Seat Back
Hinge Rod
Height Bracket
Height Bracket
Footrest
Upper Frame Assembly
Height Bracket
Red Release
Handle
Fig. 6
Fig. 7
Fig. 8