BabyTrend HC01091 - TREND HIGH CHAIR - MESA - Manual (Page 4)

Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved. Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved.
Fig. 9
Fig. 10
Hole
Hole
Push
Buttons
Hole
Push
Buttons
5 6
8. Insert the Legs into the ends of the front
tube of both the right and left Upper Frame
Assemblies (Fig. 9). Note: Legs are properly
connected when the push buttons are lined up
with the holes on the ends of the Upper Frame
Assemblies. Make sure the push buttons are
engaged before use.
9. Insert another Leg into the ends of the rear
tube of both the right and left Upper Frame
Assemblies (Fig. 10).
10. Attach each of the Casters to the high chair
feet as shown in Figure 11. Snap casters into
Bottom of the foot. Check that all four Casters
are securely fastened to the High Chair.
11. Flip over Tray to attach Crotch Retainer. The
molded plastic housing must be oriented by
facing the slot toward front of the Tray. Insert
the 4 (3.5mm X 10) Screws and tighten.
DO NOT OVER-TIGHTEN (Fig. 12).
Fig. 11
TO ATTACH SEAT PAD
NOTE: Certain High Chair models are packaged
with the High Chair Seat Pad and Seat Insert
already attached to the Seat Back. If your model
has a Seat Pad and Seat Insert on the Seat Back
please skip ahead to Step 2.
1. Loop the flap on the back of the pad over the
top of the Seat Back. Connect the Seat Pad
to the Seat Back with the two Elastic Loops.
These fit over the Attachment Tabs located near
the top harness slots (Fig. 13).
2. Attach the bottom of Seat Pad to the Seat Base
with the two Elastic loops located at the rear of
the bottom of the Seat Pad. These fit over the
Attachment Tabs located on the Seat Base near
where the Seat Back and Seat Base Join.
(Fig. 14)
3. Set Seat Insert onto Seat Pad.
4. Thread non-buckle end of Harness Straps
called Harness Attachment Tabs through the
provide slots in the Seat Fabric, Seat Insert,
Seat Back, and Seat Base (Fig. 15). When
Harness Attachment Tabs are through the
provided slots, rotate the Harness Attachment
Tabs 90 degrees. Make sure that the straps are
firmly in place.
TO REMOVE SEAT PAD
Reverse steps above.
ASSEMBLY ASSEMBLY
Fig. 12
Fig. 13
Fig. 15
Fig. 14