GlowShift Elite 10 Color Series 3,34 Inch In-Dash Speedometer Gauge - Manual

Elite 10 Color Series 3 ¾ Inch In-Dash Speedometer Gauge
For Product Numbers: GS-ET17 & GS-EWT17
Wire Harness Color Code
Red: 12v Constant (un-switched) Source (+) Black: Vehicle / Engine Ground (-)
White: 12v Ignition (switched) Source (+) Orange: 12v Dimmer (switched) Source (+) (optional)
1. Disconnect the negative battery cable.
2. Connect the white signal wire to the back of the gauge (port
C) and run it through your firewall and to your speedometer
signal wire. Cut or splice the wire so that the speedometer signal
wire can be connected inline to receive the speed signal. Make
sure all connections are covered, fastened and sealed correctly to
ensure proper operation and accuracy.

Note: If your vehicle has a cable driven transmission a
electronic speedometer conversion sensor will be needed
to complete your installation
3. Connect the white wire to a positive 12 volt ignition
(switched) source. It may be connected to the fuse panel, an
accessory wire, or any positive 12 volt source that turns on and
off with the ignition switch of the vehicle.

Note: If wiring to an un-fused source, install a 3 amp
fuse inline within 20 inches of the sources connection.
You may obtain an optional “expandable circuit”
accessory. This component easily fits into your fuse
panel and provides an additional fused power wire for
accessories such as gauges. This is available at
GlowShift.com or a local auto parts store.
4. Connect the
red wire to a positive 12 volt constant (un-
switched) source, either directly to the battery or to a fuse panel
on the vehicle.

Note: If wiring to an un-fused source, install a 3 amp
fuse inline within 20 inches of the sources connection.
You may obtain an optional “expandable circuit”
accessory. This component easily fits into your fuse
panel and provides an additional fused power wire for
accessories such as gauges. This is available at
GlowShift.com or a local auto parts store.
5. The Night Time Dimming feature decreases the brightness of the
gauge face by 30%. Connect the
orange wire to the 12 volt positive
headlamp source. This allows the mode to be activated when the
headlights come on. This step is optional and will not affect
operation of the gauge if it is omitted. NOTE: Do not connect the
orange wire to a dimmer wheel. This will cause the gauge
lighting to flicker.
6. Connect the black wire from the gauge, to any good (unpainted)
ground connection. You may also route a wire directly to the
negative side of the vehicle’s battery.
8. Speed Range Selection:

Adjust the dial switch on the back of the gauge to an
approximate range.

Move the switch from 0,9,8,7,6,5,4,3,2,1 to
narrow the speed range.

Move the switch from 1,2,3,4,5,6,7,8,9,0 to widen
the speed range.

Once you have an approximate setting, fine tune the gauge
by using the adjustment knob on the back of the gauge.
Turn the knob to pinpoint the exact MPH by using your
stock gauge. If you cannot get the MPH correct you will
have to adjust the switch.

To ensure proper calibration of the speed range selection,
remove power from the gauge, change the selection setting,
and reapply power to the gauge.
8. Reconnect the negative battery cable.
9. Daisy Chain Feature (Optional): If you are installing more
than one Elite 10 Color Gauge, you can use the daisy chain feature
to power up to 4 additional gauges. Simply plug the included daisy
chain wire into the gauge that is already powered (port B); then plug
the other end of the wire into the daisy chain port on the next gauge.