Pace-Edwards Utility Rig Rack - Manual (Page 10)

Install the rubber wear strip in the crossmember. With the aid of another person on the opposite
side of the truck, hand the correct end of the crossmember over (see drawing) and insert the
tab of the Extension Beam inside the crossmember (lifting unbolted end of the Extension Beam
is helpful in crossmember assembly). Make sure the Extension Beam and the crossmember
are seated and install a 1” carriage bolt downward through each end of the crossmember, then
install lock washers & nuts and tighten.
Complete the installation of the Extension Beam (which was left loose). It is normal to
experience some degree of effort installing the Extension Beam over the bolt on the front truss
on some models due to a tapering truck body.
STEP 9: INSTALL CR OSSMEMBER
HARDWARE USED:
5/16” STAINLESS
NUTS (x 8)
5/16” STAINLESS LOCK
WASHERS (x 8)
1” CARRIAGE BOLTS (x 8)
EXTENSION BEAM T AB FITS INSIDE
CROSSMEMBER
REAR FRONT
INSTALLA TION INSTRUCTIONS 7