Peterson AutoStrobe 490 User Manual
Page 18
Page 20
+
7
ч
+
7
ч
+
7
ч
PICK NAME = ABCDEFGH
I JKLMNOPQRSTUVWXYZ01
23456789 TMPR=B G _
< — — — — > BKSP
CNCL
1
2
3
4
1
(Press and hold)
PICK NAME = ABCDEFGH
I JKLMNOPQRSTUVWXYZ01
23456789 TMPR=B G _
< — — — — > BKSP
CNCL
1
2
3
4
Selecting the Final Character To Enter Into the New Temperament File Name
And, finally:
PICK NAME = ABCDEFGH
I JKLMNOPQRSTUVWXYZ01
23456789 TMPR=B G _
< — — — — > BKSP
CNCL
1
2
3
4
ENTER
THE NAME CHOSEN FOR
TEMPERAMENT IS: BG 1
REDO OK CNCL
1
2
3
4
Entering the Final Character Into the New Temperament File Name
You may briefly see the PICK NAME screen updated with the final name character, but this new “verify” screen will appear
as soon as you release the ENTER button at this point. On the flowchart, we have now exited the loop defined by the
“4 characters?” decision box; in other words, since we have now entered four characters into our temperament file name we
now exit through the path labeled “YES” (in answer to the “4 characters?” question). Note that, at any time up to this point,
if we had mistakenly entered an incorrect character, we could have hit the “3” button (BKSP) to backspace through the last
character entered into the name at the time. Backspacing and entering characters can be repeated indefinitely until the fourth
name character is entered and this final verify screen is activated. We still have an opportunity to start completely from
scratch in naming our temperament file by hitting the “1” (REDO) button at this point. We may also cancel the entire
temperament creation process and return to the RUN screen with no permanent changes by pressing the “3” (CNCL) button.
Typically, however, being confident and consummate professionals, we will press “2” to OK our selection:
THE NAME CHOSEN FOR
TEMPERAMENT IS: BG 1
REDO OK CNCL
1
2
3
4
2
TMPR = BG 1 KEY= C
NOTE= C 00. 0 ¢
DONE NEXT
1
2
3
4
Verify Temperament File Name and Begin Note Editing
NOTE: If you had chosen either a name that you have already used and stored in the unit or a name used as one of the
factory defaults, a different screen will be activated which indicates the problem and permits you to return to the
TEMPERAMENT MENU screen with no changes. You must then decide which course of action you wish to take: proceed
with creating a temperament file with a different name or delete the previously created user file and then create your new
temperament file using this original name.