PowerWalker ViewPower PowerWalker - Manual (Page 28)

27
SMTP information, e-mail account, and password. Besides, the sender account should
be allowed for SMTP/POP3 forwarding.
Step 1 Select ViewPower Configuration >> E-mail. Refer to Diagram 5-5.
Diagram 5-5
Step 2 Enter SMTP server, SMTP port, Send from E-mail address, User name and
password. Click checkbox of password authentication needed for password
verify.
NOTE: If using Exchange Server for mailbox system, it’s required to configure
Exchange server domain name in SMTP sever and select “Exchange
server”, then click “Apply” button.
Step 3 Enter correct e-mail accounts in E-mail column. Then click “Add” to add into
receivers list. To delete e-mail account, simply select accounts from Receivers
list and click “Delete” button.
Step 4 Click “Apply” to save all changes. The “Test” button can be used to send a test
e-mail to all receivers to confirm correct operation. When the test e-mails are
successfully sent to specific recipients, it will pop up a successful message on
operated PC. Otherwise, it will pop up a failure dialog to indicate there is an
error for parameter setting.