Peerless-AV DS-VWT955-2X2 - Installation - Manual (Page 3)

3 of 8 SHEET #: 125-9278-5 09-19-12
G
1
Secure tilt brackets ( A) to cross support tube (B) using four M8 x 16 mm phillips screws (F), four 5/16’’ split washers
( L), and four 5/16’’ flat washers (M) in desired tilt position as shown in Detail 3 and 4. Once tilt is established secure
two end caps ( C) to cross support tube (B).
2
A
A
L
M
F
Detail 3
Detail 4
5°
10° 15°
20°
Secure extension column (sold separately) to cross support ( B) using retaining collar (E), fiber washer (D), and
one M5 x 8 mm phillips screw ( G). Restrict swivel using two M6 x 6 mm set screws (K).
NOTE: Make sure that M5 x 8 mm phillips screw is positioned inside of notch of extension column as shown in
detail 2.
EXTENSION
COLUMN NOTCH
EXTENSION COLUMN
Detail 1
Detail 2
K
B
B
C
D
E