Peerless-AV WL-ESA763PU-200 - Installation - Manual (Page 11)

11 of 25 ISSUED: 08-24-12 SHEET #: 180-9034-2 10-30-12
NOTE: enclosure removed for clarity.
Begin with the longest length screw, hand thread
screw through multi-washer, display brackets (B)
and spacer in that order into display as shown
below. Screw must make at least three full turns
into the mounting hole and fi t snug into place.
Do not over tighten. If screw cannot make three
full turns into the display, select a shorter length
screw from the baffl ed fastener pack. Repeat for
remaining mounting holes, level display brackets
and tighten screws.
Skip to step 9
5-2
DISPLAY
MULTI-WASHER
SPACER
B
SCREW
Center display brackets horizontally and vertically
on back of display. Tighten two 1/4-20 x 1.25"
screws. Reinstall four 1/4-20 x .6" screws using
5mm allen wrench (I) into appropriate fi xed-stop
position from chart on page 8. 5-3
1/4-20 x 1.25" SCREWS
1/4-20 x .6" SCREWS