Peerless-AV HLGP432-C450-SM-Q10 - Installation - Manual (Page 4)

4 of 5 ISSUED: 05-25-10 SHEET #:125-9113-3 09-15-11
Hand tighten slope nut ( F) through 1/4-20 x 1 3/4" elevator bolt (E) until snug against bottom of desktop surface.
Thread another slope nut ( F) upside-down, about two turns from first slope nut (F). Insert an open box wrench
between both slope nuts ( F) and tighten. NOTE: Avoid jamming both slope nuts (F) together, doing so may make it
difficult to remove slope nut used for tightening first slope nut ( F). After slope nut is secure remove bottom slope nut
and add plastic cap ( I) as shown in figure 5.2. Repeat with remaining 1/4-20 x 1 3/4" elevator bolt (E).
Detail 1
TIGHTENING
SLOPE NUT
4
B
26" Display Base Stand Attachment Location
(note orientation of plate to base stand)
BOTTOM OF DESKTOP
FIG 5.1 FIG 5.2
E
F
E
5
I
Secure swivel plate assembly ( A) to bottom of display base stand using four flat head screws (B) in 26" or 32"
orientation.
FRONT
FRONT
NOTE: Do not overtighten slope nut (F)
plate may distort
32" Display Base Stand Attachment Location
(note orientation of plate to base stand)