Peerless-AV CM850-S - Installation - Manual (Page 15)

15 of 48 ISSUED: 07-22-08 SHEET #: 120-9055-3 10-05-11
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-865-2112
Slide one mesh sleeve (R) over each cable. Use
cable ties (O) to tighten both ends of mesh sleeves
to cables.
NOTE: Loop cable ties through cable mounts and
tighten cable and mesh sleeve to cable mounts.
Roll can be adjusted 1° clockwise or
counterclockwise.
To adjust roll, loosen M10 x 15 mm screws (I)
slightly, leaving them snug. Level display and
adapter brackets, then tighten screws (I) .
NOTE: When adjusting roll, screws should be
retightened as indicated in step 8.
Optional: To lock one sliding arm of mount in place,
slide locking tab (H) over top or bottom of sliding
arm and attach to mount using one M5 x 10 mm
screw (M) and one spacer (N).
NOTE: Full assembly/display not shown for clarity.
SLIDING ARM
H
N
M
M10 x 15 MM SCREW (I)
Optional: To lock mount in closed position, insert
one M5 x 40 mm screw (L) into tapped hole in either
top or bottom of fl at plate.
NOTE: Full assembly/display not shown for clarity.
FLAT
PLATE
TAPPED HOLE
L
O
R
TAPPED HOLE
NOTE: MOUNTING PLATE SHOW
WITHOUT FULL WALL MOUNT
ASSEMBLY FOR CLARITY.
BACK VIEW
CABLE
MOUNTS
11 12
13 14