AEG HK312000H - Manual (Page 20)

MOD.
PROD.NO.
SER.NO
DATA MOD.
PROD.NO.
SER.NO
DATA
MODEL MODEL
MOD.
PROD.NO.
SER.NO.
03 IT
MADE IN ITALY
TYPE
230V-50Hz
IP20 0049
1 2 3
1
Stick it on Guarantee Card and send
this part
2
Stick it on Guarantee Card and keep
this part
3
Stick it on instruction booklet
8. INSTALLATION
WARNING!
Refer to the Safety chapters.
8.1 Installation
WARNING!
Read and follow the instructions
carefully. There is a risk of injury
or damage to the appliance.
• Make sure that there is no damage to
the appliance from the transportation.
Do not connect a damaged appliance.
Speak to the supplier if necessary.
• Install built-in appliances only after
you assemble the appliance into cor-
rect built-in units and work surfaces.
Make sure that built-in units and surfa-
ces obey the standards.
• Obey all orders and standards in force
in the country where you use the ap-
pliance (safety standards, recycling
standards, electrical safety standards
etc.)
WARNING!
Risk of injury from electrical cur-
rent.
• The electrical mains terminal is live.
• Make electrical mains terminal free of
voltage.
• If the fixing bracket is near to the ter-
minal block, do not let the connection
cable come in contact with the edge
of the bracket.
8.2 Electrical connection
• Ground the appliance according to
safety precautions.
• Make sure that the rated voltage and
type of power on the rating plate
agree with the voltage and the power
of the local power supply.
• This appliance is supplied with a mains
cable. It has to be supplied with a cor-
rect plug, able to support the load
marked on the rating plate. The plug
has to be fitted in a correct socket.
• Any electrical component must be in-
stalled or replaced by the Service
Force Centre technician or qualified
service personnel.
• Always use a correctly installed shock-
proof socket.
20 www.aeg.com