3 replacement of the connection cable, 4 assembly – AEG HK312000H User Manual

Page 21

Advertising
background image

• Make sure that there is an access to

the mains plug after installation.

• Do not pull the mains cable to discon-

nect the appliance. Always pull the
mains plug.

• The appliance must not be connected

with an extension cable, an adapter or
a multiple connection (risk of fire).
Check that the ground connection is
in conformity with the standard and
regulations force.

• The power cable must be placed in

such a way that it does not touch any
hot part.

• Connect the appliance to the mains

with a device that lets to disconnect
the appliance from the mains at all
poles with a contact opening width of
minimum 3 mm, eg. automatic line
protecting cut-out, earth leakage trips
or fuse.

• None of a parts of the connection ca-

ble can not get a temperature 90 °C.
The blue neutral cable must be con-
nected to the terminal block label with
"N". The brown (or black) phase cable
(fitted in the terminal block contact
marked with "L") must always be con-
nected to the live phase.

8.3 Replacement of the
connection cable

To replace the connection cable use on-
ly H05V2V2-F T90 or equivalent type.
Make sure that the cable section is appli-
cable to the voltage and the working
temperature. The yellow/green earth
wire must be approximately 2 cm longer
than the brown (or black) phase wire.

8.4 Assembly

40-50 mm

55 mm

30 mm

min. 650 mm

490 mm

min. 100 mm

270 mm

Before you install the appliance into cut
out, put the sealing gasket on the edge
of cut out. The sealing gasket is supplied
with the appliance. It prevents spills from
sipping to the cabinet below.

1.

Put the sealing gasket around the
edge of cut out.

2.

Put the appliance into cut out and
secure it with the clamps. The
clamps are supplied with the acces-
sories bag (see the diagram). The
edge of the appliance top cuts the
gasket. Remove the remaining gas-
ket.

A

B

A)

seal to remove

B)

supplied clamps

CAUTION!
Install the appliance only on a
worktop with flat surface.

8.5 Possibilities for insertion

Kitchen unit with door

The panel installed below the hob must
be easy to remove and let an easy ac-
cess in case a technical assistance inter-
vention is necessary.

ENGLISH

21

Advertising
This manual is related to the following products: