Peerless-AV HDS-OWK-200 - Installation - Manual (Page 13)

13 of 22 ISSUED: 08-24-12 SHEET #: 180-9029-2 10-30-12
Align one display bracket with one set of display mounting holes. Place spacers between display bracket and
display. Begin with the longest length screw, hand thread screw through the multi-washer, display brackets, and
spacer into display as shown. Screw must make at least three full turns into the mounting hole and fi t snug into
place. Do not over tighten. If screw cannot make three full turns into the display, select a shorter length screw
from the baffl ed fastener pack. Center display brackets vertically and tighten screws.
Slide universal adapter bracket to the opposite side to expopse the display bracket mounting slots. Place spacers
between display bracket and display. Begin with the longest length screw, hand thread screw through the multi-
washer, display brackets, and spacer into display as shown. Screw must make at least three full turns into the
mounting hole and fi t snug into place. Do not over tighten. If screw cannot make three full turns into the display,
select a shorter length screw from the baffl ed fastener pack. Center display brackets vertically and tighten
screws.
SCREW
SCREW
MULTI-
WASHER
MULTI-
WASHER
SPACER
SPACER
DISPLAY
BRACKET
DISPLAY
BRACKET
6-4
6-5