Peerless-AV HDS-OWK-200 - Installation - Manual (Page 18)

18 of 22 ISSUED: 08-24-12 SHEET #: 180-9029-2 10-30-12
If you have any questions, please call Peerless customer care at 1-800-865-2112.
Begin with longer length screw, hand thread through multi-washer, tilt bracket and spacer in that order into display
as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws. 10-1
DISPLAY
MULTI-WASHER
SCREW
TILT BRACKET
fi g. 10.1
SPACER