Fig. 8.2, Fig. 8.1 – Peerless-AV DST965 - Installation User Manual

Page 9

Advertising

9 of 11

ISSUED: 10-24-11 SHEET #: 125-9260-2 2-1-13

Begin with the shortest length screw, hand thread through multi-washer and adapter bracket into screen as

shown below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not

over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffled

fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

NOTE: Spacers may not be used, depending upon the type of screen.

Begin with longer length screw, hand thread through multi-washer, adapter bracket and spacer in that order into

screen as shown below. Screw must make at least three full turns into the mounting hole and fit snug into place.

Do not over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the

baffled fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

For Flat Back Screen

For Bump-out or Recessed Back Screen

8-1

8-2

If you have any questions, please call Peerless customer care at

1-800-865-2112.

If you have any questions, please call Peerless customer care at

1-800-865-2112.

DISPLAY

MULTI-WASHER

SCREW

ADAPTER

BRACKET

(

BB)

fig. 8.2

SPACER

fig. 8.1