Knape&Vogt PB-3126 Side wall bracket - Manual

SLIDING DOOR HARDWARE:
Side Wall Mount Bracket -
PB-3126
Assembly
Instructions
Phillips Screw Driver • Tournevis Phillips • Destornillador Phillips
Drill (13/64") • Perceuse (13/64") • Taladro (13/64")
Tools Required • Outils requis • Herramientas requeridos
CONTENTS QTY
A. Side Wall Bracket Assembly 1
B. #10 x 3/8" Tapping Screw 1
C. White Rubber End Cap 1
D. 3/4" Spacer Washer 1
E. #10 x 1-1/2" Tapping Screw 1
#310377_A (0513)
1. Determine the point on the wall where the end of the track will fall. Find the nearest stud. If greater than 8" from the end of
the track, or if the door weight exceeds 100 lbs., install blocking secured to wall structure to support the end of the track
within 8" of the nearest stud. Layout the stud position on the track and mark each successive stud location.
2. If holes are not present in the track at the locations marked, additional 13/64" holes must be drilled through the top of the
track on center at the stud locations.
3. Thread the supplied #10 x 3/8" screws into the side wall mount brackets through the track holes. Hand tighten only to snug
so that the head of the screw is tight against the track and the bracket above is tight against the track.
4. Place white rubber end caps over protruding screw points.
5. Placing the spacer washer between the side wall bracket and the wall, attach track to wall using #10 x 1-1/2" screws
through the bracket and washer per the above fastening instructions. It is critical that the track be installed level or the door
will not stay in position and roll freely.
A.
C.
D.
E.
B.
Door Weights from 100 to
150 lbs. (2001 Track): If the
door weight is greater than 100
lbs., and not more than 150 lbs.,
secure side wall mount brackets
to wood header and studs on 16"
centers as well as at both ends
of the track.
Door Weights up to 100 lbs.
(1599/1601 Track): If the door
weight is less than 100 lbs.,
secure side wall mount brackets
to wood header and studs on
16" centers with no more than
8" unsupported track at the
track ends.
Minimum Number of Sidewall Bracket Assemblies per Track Length:
4' = 3 • 5' = 4 • 6' = 5 • 8' = 6 • 12' = 10
Wall
Mur
Pared
Wall
Mur
Pared
Spacer Washer
Rondelle d’espacement
Arandela espaciadora
Spacer Washer
Rondelle d’espacement
Arandela espaciadora
Long screw through bracket
and spacer into wall
Longue vis inséré dans le
support, la rondelle et le mur
Tornillo largo a tracés del
soporte y espaciador en la
pared
Long screw through bracket and
spacer into wall
Longue vis inséré dans le support,
la rondelle et le mur
Tornillo largo a tracés del soporte
y espaciador en la pared